Overview

The NZTA preference is to have one standard check sheet that is used by all border inspection service providers.

General requirements applicable to all check sheets

• The check sheet must contain an ‘Appointed by NZ Transport Agency’ logo. Please email Vehicle Regulation Technical for requirements for the use of the logo.
  vehicleregulationtechnical@nzta.govt.nz
• The check sheet must contain the version number and/or version date of the check sheet (eg 5/09, indicating that the check sheet was last approved/changed in May 2009).
• The check sheet must include the following information:
  • The words: ‘Complaints regarding border inspection issues should be first directed to the border inspection organisation’. Additional words may be added to the check sheet to meet the requirements for complaint statements contained in the Introduction section of the VIRM.
    Introduction
  • The words ‘NZ Transport Agency reserves the right to recheck any vehicle following an inspection.’

Items to be on the check sheet

• The check sheet shall contain all the items to be recorded and checked by the vehicle inspector during a border inspection.
• Any additional items included must be relevant to the inspection requirements in the VIRM.

Items required to be recorded on all check sheets

• Inspecting Organisation name
• Address where inspection was carried out
• Vehicle Make
• Vehicle Model
• Vehicle Identification Number (VIN)
• Inspection date
• Vehicle Inspector’s name
• Vehicle Inspector’s signature
• Indication of vehicle structural inspection pass or fail
• Diagram of vehicle/s
• For damaged vehicles a check list (see below) detailing type of damage and where damage is located on the vehicle
  • Damage
  • Rust
  • External
  • Under body
  • Internal
  • Front
  • Rear
  • Side
  • Left
  • Right
• Odometer reading
• Left-hand-drive/right-hand-drive
• Provision for notes to be recorded.