Lighting
4-9 End-outline marker lamps (heavy vehicles)
Reasons for rejection
Mandatory requirements
1. A vehicle does not comply with a requirement relating to mandatory equipment set out in the VIRM: In-service certification, section 4-9.
Compliance with approved standards
2. An end-outline marker lamp that is required to comply with an approved end-outline marker lamp standard does not comply, or cannot be demonstrated to comply, with at least one of the standards listed in Table 4-9-1.
Condition and performance
3. An end-outline marker lamp does not comply with a requirement relating to condition or performance set out in the VIRM: In-service certification, section 4-9.
Table 4-9-1. Approved end-outline marker lamp standards*
|
UN-ECE Regulation no. |
EEC/EC Directive |
FMVSS |
ADR |
Japan |
|---|---|---|---|---|
|
7 |
76/758 |
108 |
49 |
JIS D5500 TS for front end outline marker lamps TS for rear end outline marker lamps |
* An end-outline marker lamp that is required to comply with an approved end-outline marker standard must comply with at least one of the standards listed in the table.
Summary of legislation
Applicable legislation
Mandatory, permitted and prohibited equipment
1. Vehicles must comply with the requirements relating to mandatory, permitted and prohibited equipment set out in the VIRM: In-service certification, section 4-9.
Compliance with approved standards
2. End-outline marker lamps fitted to the following vehicles must comply with one or more of the approved end-outline marker standards in Table 4-9-1:
- vehicles of class MD3, MD4, ME, NB NC, TC and TD manufactured on or after 1 January 2006.
Condition and performance
3. End-outline marker lamps must comply with the requirements relating to condition and performance set out in the VIRM: In-service certification, section 4-9.